CART
Empty

Rubber Floor Sealer, Cleaner and Disinfectant Instructions

Animal Rubber Flooring - Doggy Daycare Flooring, Kennel Flooring and More With CleanBreak Rubber Sealant, Cleaner and Disinfectant
Dog Agility Surface with Rubber Sealant Being Used

1. Initial and Regular Maintenance

Remove all surface dirt and debris by vacuuming, sweeping or using a damp sponge mop. Commercial grade electric floor scrubber-extractor is HIGHLY recommended for large or high traffic areas. If using a commercial grade electric floor scrubber-extractor, use the softest bristle attachment available with a minimum amount of pressure.

Clean/ scrub area using sponge mop or scrubber/extractor with Clean Break Cleaners/Degreasers or approved neutral pH (7-9), low voc cleaner mixed to the manufacturer instructions. Do not use strong chemical cleaners such as ammonia, bleach, solvents or petroleum based products.

A. Remove soiled solution with a sponge mop or floor extractor.
B. Allow to dry before use.

Do not pressure wash a rubber floor, do not spray with a hose or otherwise flood the floor. Do not use a squeegee on the floor.


2. Disinfecting Rubber Flooring and Surface Area

Clean flooring according to the above instructions. We recommend using Clean Break Disinfectant per manufacturer’s directions in a hand-pump garden sprayer. Lightly mist all surfaces with the recommended dilution and allow the surfaces to dry before use.


3. Rubber Floor Sealing Process

Clean flooring according to the above instructions. It is not necessary to disinfect the rolled rubber prior to sealing.

Each gallon of Clean Break Rubber Flooring Sealant covers 500 sq. ft. for the first coat and then 1,000 sq. ft. for a second coat.

Pour sealer in new paint tray. Use a paint pad with a broom handle or a lint-free short-napped roller to "paint or coat" the sealer onto the floor. Start coating the floor in a corner or the wall farthest from the door and work your way across the floor to the entrance of the room . Allow the sealer to dry overnight or at least 8 hours at 60 to 70 degrees, ventilation and humidity may extend the cure time. DO NOT WALK ON THE WET SEALER. You MUST allow the first coat to completely cure before applying additional coats of sealer.


4. Spot Cleaning

A. Non-Animal Liquid Spills
Remove non-animal liquid spills with a clean, dry, lint-free cloth. Then clean the affected area using a damp sponge mop with a solution of Cleanbreak Cleaner-Degreaser mixed to the manufacturer's directions.

B. Pet Urine or Solid Waste
Remove solid waste and excess moisture with a lint-free or disposable cloth. Clean affected area using a damp sponge mop with a solution of Cleanbreak Cleaner-Degreaser mixed to the manufacturer's directions. If using Cleanbreak Disinfectant, mist area and allow to dry.

Do not use strong chemical cleaners such as ammonia, bleach, solvents or petroleum based products.